TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Quick question on an impeller
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="kofkorn" data-source="post: 383594" data-attributes="member: 7076"><p>Water coming out of the motor should be warm (once the motor's warmed up). It shouldn't be too hot to hold your hand under. If you replaced your impeller this past fall before putting away, there should be no need to replace it again unless you've run the motor without the lower leg in water. If the water is coming out hot (can't keep your hand in the stream for more than 1 second), then you may have to start looking at the possibility of blockages somewhere in your cooling system. </p><p></p><p>I'd say from your description that you should be ok.</p></blockquote><p></p>
[QUOTE="kofkorn, post: 383594, member: 7076"] Water coming out of the motor should be warm (once the motor's warmed up). It shouldn't be too hot to hold your hand under. If you replaced your impeller this past fall before putting away, there should be no need to replace it again unless you've run the motor without the lower leg in water. If the water is coming out hot (can't keep your hand in the stream for more than 1 second), then you may have to start looking at the possibility of blockages somewhere in your cooling system. I'd say from your description that you should be ok. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Quick question on an impeller
Top