TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
rear bench to split bench
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="vahunter" data-source="post: 347353" data-attributes="member: 6815"><p>Been super busy so its been slow but steady on the boat. Got a couple pieces done, 2 pieces for added support for the pedestals which you cant see but its an oversized backing plate that I bent basically C channel on one end 1/2" by 1" which will tie-in to the upper 1x1 angle on the seat frame. The other piece i got done is the floor piece. Next will be the side plates and hinges.</p><p></p><p>One thing I cant make my mind up on is: using 4 buttonhead screws to fasten the hatch down or get a hatch latch. They're about $25 a piece though. All that will be in there is an onboard battery charger, battery and access to switch panel wiring and fuses.[attachment=-1]uploadfromtaptalk1396542141845.jpg[/attachment]</p></blockquote><p></p>
[QUOTE="vahunter, post: 347353, member: 6815"] Been super busy so its been slow but steady on the boat. Got a couple pieces done, 2 pieces for added support for the pedestals which you cant see but its an oversized backing plate that I bent basically C channel on one end 1/2" by 1" which will tie-in to the upper 1x1 angle on the seat frame. The other piece i got done is the floor piece. Next will be the side plates and hinges. One thing I cant make my mind up on is: using 4 buttonhead screws to fasten the hatch down or get a hatch latch. They're about $25 a piece though. All that will be in there is an onboard battery charger, battery and access to switch panel wiring and fuses.[attachment=-1]uploadfromtaptalk1396542141845.jpg[/attachment] [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
rear bench to split bench
Top