TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Recessed TM Tray - Tracker 170
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="tgaab" data-source="post: 462333" data-attributes="member: 24406"><p>Hi Everyone - I have a Tracker 170 and just upgraded to a 24v TM. Since there was no access to unbolt the old TM without removing the whole deck and since a recessed tray has always been on my list of eventual projects, I pulled the trigger and cut a hole for it. The only thing I am getting stuck on is how to run the drain tube. Does anyone know the best place to run it or done this before on a Tracker? I've done a lot of googling, but can't seem to find anything helpful. Can I just dig through the foam until i reach the hull and run it straight down to the bottom of the boat? Or do I need to run it somewhere specific (i.e. keel drain, if I even have one)? </p><p></p><p>In the pic you can see I started digging back and to the left, but it wasn't looking too promising so I decided to hold off on removing more foam for now. </p><p></p><p>I would appreciate any thoughts!</p></blockquote><p></p>
[QUOTE="tgaab, post: 462333, member: 24406"] Hi Everyone - I have a Tracker 170 and just upgraded to a 24v TM. Since there was no access to unbolt the old TM without removing the whole deck and since a recessed tray has always been on my list of eventual projects, I pulled the trigger and cut a hole for it. The only thing I am getting stuck on is how to run the drain tube. Does anyone know the best place to run it or done this before on a Tracker? I've done a lot of googling, but can't seem to find anything helpful. Can I just dig through the foam until i reach the hull and run it straight down to the bottom of the boat? Or do I need to run it somewhere specific (i.e. keel drain, if I even have one)? In the pic you can see I started digging back and to the left, but it wasn't looking too promising so I decided to hold off on removing more foam for now. I would appreciate any thoughts! [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Recessed TM Tray - Tracker 170
Top