TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Removing T&T 2000 40HP Johnson
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Glades" data-source="post: 488502" data-attributes="member: 21776"><p>Any suggestions on getting the top pin out that the T&T rotates on.</p><p></p><p>Yes I removed the cotter pin on the starboard side. I also cut out a little of the bracket on the starboard side for easy access to the pin with a punch</p><p></p><p>I had a slide hammer, air hammer guns, 4lb hammer w a big punch, heated the surrounding frame with MAP gas.</p><p>And yes put a lot of PB blaster on it.</p><p></p><p>Will not budge.</p><p>Then I cut the flange off the port side to see if I could get it to move from there and again no luck</p><p></p><p>I'm tempted to get up under there and cut the pin on both sides of the tilt ram to at least get the T&T out to get it rebuilt.</p><p></p><p>Wondered what your thoughts are.</p><p>Thanks</p></blockquote><p></p>
[QUOTE="Glades, post: 488502, member: 21776"] Any suggestions on getting the top pin out that the T&T rotates on. Yes I removed the cotter pin on the starboard side. I also cut out a little of the bracket on the starboard side for easy access to the pin with a punch I had a slide hammer, air hammer guns, 4lb hammer w a big punch, heated the surrounding frame with MAP gas. And yes put a lot of PB blaster on it. Will not budge. Then I cut the flange off the port side to see if I could get it to move from there and again no luck I'm tempted to get up under there and cut the pin on both sides of the tilt ram to at least get the T&T out to get it rebuilt. Wondered what your thoughts are. Thanks [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Removing T&T 2000 40HP Johnson
Top