TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
rod tube help???? FINISHED PROJECT!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bassboy1" data-source="post: 182314" data-attributes="member: 55"><p>I can't see the picture where I'm at (stupid censor), but based on what I think the picture has, I'd take Ahab's idea, but instead of just putting a square over the hole, I'd cut a panel to fit the opening entirely, so it doesn't appear to be a patch. </p><p></p><p>Is there nothing to support them up front? On the build I used them in, there was flotation foam up under the deck, so coring that out, they were well supported and snugly held through the entire length. If there was nothing to support them, I'd probably cut a large enough opening that a front support could fit in, then use the patch panel to hold the back end of the tubes.</p></blockquote><p></p>
[QUOTE="bassboy1, post: 182314, member: 55"] I can't see the picture where I'm at (stupid censor), but based on what I think the picture has, I'd take Ahab's idea, but instead of just putting a square over the hole, I'd cut a panel to fit the opening entirely, so it doesn't appear to be a patch. Is there nothing to support them up front? On the build I used them in, there was flotation foam up under the deck, so coring that out, they were well supported and snugly held through the entire length. If there was nothing to support them, I'd probably cut a large enough opening that a front support could fit in, then use the patch panel to hold the back end of the tubes. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
rod tube help???? FINISHED PROJECT!
Top