TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Sea foam deep creep in 9.9
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jmar" data-source="post: 411374" data-attributes="member: 20812"><p>Thanks. The first time I fired it up I noticed no water was coming out of the tell tale and I cleared out the tube then installed a new impeller and it works perfect now. Earlier I added some quicksilver fuel treatment to the gas tank and ran it through. It did smoke some, but not to much. That's why I grabbed the sea foam. How exactly do I spray it in the carb? Do I remove the tube where the fuel goes in and spray there? Sorry, total newbie to 2 stroke motors.</p></blockquote><p></p>
[QUOTE="Jmar, post: 411374, member: 20812"] Thanks. The first time I fired it up I noticed no water was coming out of the tell tale and I cleared out the tube then installed a new impeller and it works perfect now. Earlier I added some quicksilver fuel treatment to the gas tank and ran it through. It did smoke some, but not to much. That's why I grabbed the sea foam. How exactly do I spray it in the carb? Do I remove the tube where the fuel goes in and spray there? Sorry, total newbie to 2 stroke motors. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Sea foam deep creep in 9.9
Top