TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
seat strength alumacraft mv1648
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mms" data-source="post: 400543" data-attributes="member: 20273"><p>I'm considering purchasing a new alumacraft MV1648 ss.</p><p></p><p>I have a question on adding the flush fit 3/4 swivel seats. I'm a big guy 300lbs from what i have found on the installation its just 6 screws strait into the aluminum of the current seat. is that really a secure mounting? </p><p></p><p>how thick is the aluminum used in the seats both the split rear sear and the middle bench is there enough there that the screws wont strip out. (the hull is only .07) </p><p></p><p>ideally i would like to run 5 bases, 1 on each of the split seats in the rear, one on each side of the storage compartment of the center bench and one in the front. I would probably only take 2 seats on the boat but this way i have flexibility in where I put them.</p></blockquote><p></p>
[QUOTE="mms, post: 400543, member: 20273"] I'm considering purchasing a new alumacraft MV1648 ss. I have a question on adding the flush fit 3/4 swivel seats. I'm a big guy 300lbs from what i have found on the installation its just 6 screws strait into the aluminum of the current seat. is that really a secure mounting? how thick is the aluminum used in the seats both the split rear sear and the middle bench is there enough there that the screws wont strip out. (the hull is only .07) ideally i would like to run 5 bases, 1 on each of the split seats in the rear, one on each side of the storage compartment of the center bench and one in the front. I would probably only take 2 seats on the boat but this way i have flexibility in where I put them. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
seat strength alumacraft mv1648
Top