TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
side reinforcement?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="nated." data-source="post: 409225" data-attributes="member: 20654"><p>Many thanks to all, </p><p>the boat will be used in 18 inch choppy water seas to at most 2 foot white caps bigger than that and i'm headed to the boat ramp. yes a 15 hp 4 stroke is on the tin can. I'm going to go with a piece of 2 inch angle on the outside running parallel to the bottom spray rail. inside there will be more 2 inch angle at all bench seat attachment points riveted into the exterior two inch angle where possible. i'll go with 6061 T-6, 1/8 inch wall thickness if that is available. I do agree with everyone, removing the bench seats removed the cross bracing and a bad idea. I want a bottom floor only, not interested in any elevated platforms.</p></blockquote><p></p>
[QUOTE="nated., post: 409225, member: 20654"] Many thanks to all, the boat will be used in 18 inch choppy water seas to at most 2 foot white caps bigger than that and i'm headed to the boat ramp. yes a 15 hp 4 stroke is on the tin can. I'm going to go with a piece of 2 inch angle on the outside running parallel to the bottom spray rail. inside there will be more 2 inch angle at all bench seat attachment points riveted into the exterior two inch angle where possible. i'll go with 6061 T-6, 1/8 inch wall thickness if that is available. I do agree with everyone, removing the bench seats removed the cross bracing and a bad idea. I want a bottom floor only, not interested in any elevated platforms. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
side reinforcement?
Top