TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="smackdaddy53" data-source="post: 351135" data-attributes="member: 10154"><p>About to get the top cap on the boat and temporarily screwed down so I can fit a few pieces to be welded up at 1pm at my buds shop. Fabbing a trolling motor mounting plate on the front deck, getting the very front deck rubrail fitted, inside perimeter 2x3 angle fitted and a couple of other pieces cut and welded so I can start prepping for primer and Tuffcoat application. I bought my pneumatic texture hopper yesterday to apply the Tuffcoat with and get into those hard to reach areas. I will take some pictures as I go and post up tonight. If all goes as planned I will be priming this evening or in the morning then blowing my first coat on tomorrow by lunch hopefully. Then it is on to rigging!</p></blockquote><p></p>
[QUOTE="smackdaddy53, post: 351135, member: 10154"] About to get the top cap on the boat and temporarily screwed down so I can fit a few pieces to be welded up at 1pm at my buds shop. Fabbing a trolling motor mounting plate on the front deck, getting the very front deck rubrail fitted, inside perimeter 2x3 angle fitted and a couple of other pieces cut and welded so I can start prepping for primer and Tuffcoat application. I bought my pneumatic texture hopper yesterday to apply the Tuffcoat with and get into those hard to reach areas. I will take some pictures as I go and post up tonight. If all goes as planned I will be priming this evening or in the morning then blowing my first coat on tomorrow by lunch hopefully. Then it is on to rigging! [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
Top