TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="smackdaddy53" data-source="post: 362750" data-attributes="member: 10154"><p>I got the wiring almost done today. Now I have to mount my fuse/ACR/Perko panel and switch board and get all the wires tidied up with zip ties and wire clips. What a mess! </p><p>[ATTACH=full]66836[/ATTACH][ATTACH=full]66837[/ATTACH]</p><p>I checked my starter for the first time in over a year and it still cranks but now with the key! I also found out my Oil Warning Module is bad because it started smoking and nearly caught my fuel pump on fire. Good thing I had the cowling off and was standing on the ground turning the key and watching the motor. New part on the way. I also went ahead and bought a new oil tank for the motor because the last guy that had it cut a hole in the side of it to check or disable the oil float...Paul!!!!! No big deal but I will not have a motor without an oil and temperature alarm. </p><p>I will be drilling the hole in the bow deck for my fuel fill fitting and getting all the gauges hooked up as well in the next few days. </p><p>More to come over the next several days, there is light at the end of the tunnel! I hope to be at least launching next week and running it some if everything goes as planned.</p></blockquote><p></p>
[QUOTE="smackdaddy53, post: 362750, member: 10154"] I got the wiring almost done today. Now I have to mount my fuse/ACR/Perko panel and switch board and get all the wires tidied up with zip ties and wire clips. What a mess! [ATTACH type="full" alt="ImageUploadedByTapatalk1407544287.698707.jpg"]66836._xfImport[/ATTACH][ATTACH type="full" alt="ImageUploadedByTapatalk1407544311.080929.jpg"]66837._xfImport[/ATTACH] I checked my starter for the first time in over a year and it still cranks but now with the key! I also found out my Oil Warning Module is bad because it started smoking and nearly caught my fuel pump on fire. Good thing I had the cowling off and was standing on the ground turning the key and watching the motor. New part on the way. I also went ahead and bought a new oil tank for the motor because the last guy that had it cut a hole in the side of it to check or disable the oil float...Paul!!!!! No big deal but I will not have a motor without an oil and temperature alarm. I will be drilling the hole in the bow deck for my fuel fill fitting and getting all the gauges hooked up as well in the next few days. More to come over the next several days, there is light at the end of the tunnel! I hope to be at least launching next week and running it some if everything goes as planned. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Smackdaddy's "Pole Dancer" 1652 Polar Kraft flush deck jet b
Top