TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Some questions on finishing my 14' mod v mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Macrosill" data-source="post: 427832" data-attributes="member: 11079"><p>After searching through pages and pages of mod builds I am thinking about removing all the seats and start with an empty hull. Then lay down a complete floor, bow to stern. Then start my build from there. instead of piecing sections between the 2 remaining seats.</p><p></p><p>I would add foam under the floor the entire length as well as any unused crevices to make up for the lost foam from the seats. Also the aluminum angle I will be using to build the platforms would replace the seats that connect the gunwales together. And the side storage areas will replace some of the strength that was lost when the middle seat was removed.</p><p></p><p>Thoughts on starting with an empty hull vs keeping to front and rear seat in place and working around them?</p></blockquote><p></p>
[QUOTE="Macrosill, post: 427832, member: 11079"] After searching through pages and pages of mod builds I am thinking about removing all the seats and start with an empty hull. Then lay down a complete floor, bow to stern. Then start my build from there. instead of piecing sections between the 2 remaining seats. I would add foam under the floor the entire length as well as any unused crevices to make up for the lost foam from the seats. Also the aluminum angle I will be using to build the platforms would replace the seats that connect the gunwales together. And the side storage areas will replace some of the strength that was lost when the middle seat was removed. Thoughts on starting with an empty hull vs keeping to front and rear seat in place and working around them? [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Some questions on finishing my 14' mod v mod
Top