TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Stuck Seats
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="HarryO60" data-source="post: 395757" data-attributes="member: 19564"><p>Nice job of getting the old mounts out with minimal damage. If this was my project and the hole was large enough for me to get my hand inside I would coat both the interior and exterior of the mounting area with a sealer like Gluvit. I'd then bolt the new seat mounts in using T-nuts after drilling out the new mounting pattern. The T-nuts will spread the load over a wider area and your can seal them with more Gluvit.</p></blockquote><p></p>
[QUOTE="HarryO60, post: 395757, member: 19564"] Nice job of getting the old mounts out with minimal damage. If this was my project and the hole was large enough for me to get my hand inside I would coat both the interior and exterior of the mounting area with a sealer like Gluvit. I'd then bolt the new seat mounts in using T-nuts after drilling out the new mounting pattern. The T-nuts will spread the load over a wider area and your can seal them with more Gluvit. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Stuck Seats
Top