TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
tach options for 2 stroke?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BassNBob" data-source="post: 44119" data-attributes="member: 630"><p>I just recently purchased a Tiny Tach for my 25HP Nissan and quickly installed it on the motor and then ran the water muff to the motor to see what was going to happen. My motor is supposed torun between 5000 and 6000 RPMs at WOT. I didn't make to WOT because it was reading 6240 at on point so I backed off. At idle speed the RPMs were 1800 or so.</p><p>When I get back from MN. fishing for a week I will go to the lake and try it out again.</p></blockquote><p></p>
[QUOTE="BassNBob, post: 44119, member: 630"] I just recently purchased a Tiny Tach for my 25HP Nissan and quickly installed it on the motor and then ran the water muff to the motor to see what was going to happen. My motor is supposed torun between 5000 and 6000 RPMs at WOT. I didn't make to WOT because it was reading 6240 at on point so I backed off. At idle speed the RPMs were 1800 or so. When I get back from MN. fishing for a week I will go to the lake and try it out again. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
tach options for 2 stroke?
Top