TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Tilt bolt & spring removal.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="timberwolves" data-source="post: 366905" data-attributes="member: 15129"><p>Any advice on how to remove the tilt bolt and spring on my 1976 Evinrude 6 hp model 6604. The motor is tough to tilt up and down almost like its seizing up. The past few days I have been spraying the area with PB Blaster, and working it up and down. I also removed the nut and washer but it has not freed up any. Its still hard to tilt the motor. How do I remove the tilt spring & bolt ? I placed a block of wood on the end of it and gave it a few shots with a lump hammer but nothing. I was thinking that if I can remove the bolt ,washers & spring I could clean them up and put some anti-seize on them. Thanks for the help. John</p></blockquote><p></p>
[QUOTE="timberwolves, post: 366905, member: 15129"] Any advice on how to remove the tilt bolt and spring on my 1976 Evinrude 6 hp model 6604. The motor is tough to tilt up and down almost like its seizing up. The past few days I have been spraying the area with PB Blaster, and working it up and down. I also removed the nut and washer but it has not freed up any. Its still hard to tilt the motor. How do I remove the tilt spring & bolt ? I placed a block of wood on the end of it and gave it a few shots with a lump hammer but nothing. I was thinking that if I can remove the bolt ,washers & spring I could clean them up and put some anti-seize on them. Thanks for the help. John [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Tilt bolt & spring removal.
Top