TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
To Rivet or To Screw: Marine vinyl / plywood floor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="FishinLite" data-source="post: 445974" data-attributes="member: 17366"><p>I went with screws and made a template from 1/4" hardboard. I located all the original screw hole with a tape measure, story sticks & painters tape.</p><p>I transferred the screw holes to the template aligned the template with two awls and screwed the template to the boat ribs. The template was in and out of the boat a half a dozen times.</p><p></p><p>Once I was comfortable with the template I fabricated the floor panels. Approx. 11' x 5'</p><p></p><p>[ATTACH=full]95777[/ATTACH]</p><p></p><p>If you look closely, you can see all the hole in the floor panel. There are over 100 stainless screws in the floor.</p><p></p><p>I then carpeted the floor panel. Marked the holes through the carpet with fishing line and installed the panel.</p></blockquote><p></p>
[QUOTE="FishinLite, post: 445974, member: 17366"] I went with screws and made a template from 1/4" hardboard. I located all the original screw hole with a tape measure, story sticks & painters tape. I transferred the screw holes to the template aligned the template with two awls and screwed the template to the boat ribs. The template was in and out of the boat a half a dozen times. Once I was comfortable with the template I fabricated the floor panels. Approx. 11' x 5' [ATTACH type="full" alt="20170601_150118.jpg"]95777._xfImport[/ATTACH] If you look closely, you can see all the hole in the floor panel. There are over 100 stainless screws in the floor. I then carpeted the floor panel. Marked the holes through the carpet with fishing line and installed the panel. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
To Rivet or To Screw: Marine vinyl / plywood floor
Top