TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Trailers
Trailer Project (a couple more new pictures!)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BassBlaster" data-source="post: 134470" data-attributes="member: 2865"><p>Just measure the inside of the bearing when you take the old hub off. Most of them are pretty standard 1" but there are some oddball sizes out there. I have seen spindles that step down even or bottle neck, where it would require a smaller bearing in the front of the hub, if that makes since.</p></blockquote><p></p>
[QUOTE="BassBlaster, post: 134470, member: 2865"] Just measure the inside of the bearing when you take the old hub off. Most of them are pretty standard 1" but there are some oddball sizes out there. I have seen spindles that step down even or bottle neck, where it would require a smaller bearing in the front of the hub, if that makes since. [/QUOTE]
Verification
Post reply
Forums
Boats
Trailers
Trailer Project (a couple more new pictures!)
Top