TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Off The Water
Watering Hole
Truck tool box for bench seat in re build?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="WVfishnfool" data-source="post: 358819" data-attributes="member: 10364"><p>Most of the lids have a stiffener welded in them across the width to kepp them from sagging. The bottom does not on any of the boxes therefore that's why the side box he put on the truck began sagging underneath. The tool boxes made for the bed of the truck will sag on the bottom as well unless supported so if you're going to make the seat out of a used box check to make sure the bottom isn't rounded out to bad other wise it won't set flat.</p></blockquote><p></p>
[QUOTE="WVfishnfool, post: 358819, member: 10364"] Most of the lids have a stiffener welded in them across the width to kepp them from sagging. The bottom does not on any of the boxes therefore that's why the side box he put on the truck began sagging underneath. The tool boxes made for the bed of the truck will sag on the bottom as well unless supported so if you're going to make the seat out of a used box check to make sure the bottom isn't rounded out to bad other wise it won't set flat. [/QUOTE]
Verification
Post reply
Forums
Off The Water
Watering Hole
Truck tool box for bench seat in re build?
Top