TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
UHMW usage on a jetjon, thoughts/advice needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="CedarRiverScooter" data-source="post: 403727" data-attributes="member: 15465"><p>WD - A low cost compromise would be to add aluminum sheet to the inside of your hull. I did this next to my engine installation to stiffen things up. Obviously you can't go under the braces, but can go in between them. I glued the alum down with roof sealant Locktite S30.</p></blockquote><p></p>
[QUOTE="CedarRiverScooter, post: 403727, member: 15465"] WD - A low cost compromise would be to add aluminum sheet to the inside of your hull. I did this next to my engine installation to stiffen things up. Obviously you can't go under the braces, but can go in between them. I glued the alum down with roof sealant Locktite S30. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
UHMW usage on a jetjon, thoughts/advice needed
Top