TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
What sealant between transom boards/transom?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wihil" data-source="post: 222535" data-attributes="member: 6487"><p>Finally got the plywood all sealed up with Spar, got the holes cleaned up, transom cleaned up, and all the stainless hardware purchased.</p><p></p><p>I'm ready to mount the boards back onto the boat, but was wondering what to use for a sealant around where the bolts pass through the transom. The boards I took off were put there from the factory back in the 50's, and whatever they used was black and a pain in the rear to strip off with the wire brush.</p><p></p><p>I'd rather not make it permanent, as I hope to Flex Steel the boat next summer and I'd hate to have to ruin the boards to get everything apart to do it all over again after the paint.</p><p></p><p>Any ideas?</p><p></p><p>C</p></blockquote><p></p>
[QUOTE="wihil, post: 222535, member: 6487"] Finally got the plywood all sealed up with Spar, got the holes cleaned up, transom cleaned up, and all the stainless hardware purchased. I'm ready to mount the boards back onto the boat, but was wondering what to use for a sealant around where the bolts pass through the transom. The boards I took off were put there from the factory back in the 50's, and whatever they used was black and a pain in the rear to strip off with the wire brush. I'd rather not make it permanent, as I hope to Flex Steel the boat next summer and I'd hate to have to ruin the boards to get everything apart to do it all over again after the paint. Any ideas? C [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
What sealant between transom boards/transom?
Top