A freind bought a boat with a motor guide trolling motor on it. It says 101lb 36volt but its wired 24 volt. The guy said he had a dealer change it to 88 lb trust. Anybody ever heard of doing this? Why would you do this?
Started right up ran good at full throttle for 2 minutes and slowly died. Fired back up and ran perfect the rest of the day. Issues are better but not solved.
I cut my shaft down but not the wires. There was plenty of room in the shaft for the wires to fit in. I wouldn't use anything hotter than propane. You don't want to melt the aluminum.
I used different size deep well socked and drove them in to open it up. Still not perfect but I can get a plug to seal. Works better if I plug from the outside.
I've had good luck with the jb weld. Just scuff the area good with rough sand paper to give it something to stick to. I was wandering about ll tis epoxy everyone is using. It seals up great but when damage happens... And it will. Nothing will stick to it. Cant weld with it on there. I used some...