Recent content by tadpole86

Not too difficult. Just make sure that your motor was made by eska before the buy that carb kit. My father helped me with the rebuild because he has more experience with that type of thing but it did not take that long at all. There are a couple basic guidelines with the kit to go by and just...

https://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=110522038068&viewitem=&sspagename=STRK:MEWNX:IT#ht_2992wt_732

For now only one battery but eventually two batteries. I was just pondering the idea and I appreciate the input. I should probably just hold off any lights and when I finally do it just put in the proper lights.

Bought the carb kit and installed it. It starts and runs strong now however it does still go up and down a little bit on its own. I can send you the link the seller on ebay from whom I bought the kit from. Bought a fuel filter to install then going to run some stabil through it which should...

Actually by 2nd and 3rd fish of the season but here are a couple decent size brookies from the maury river(goshen pass) in va. 16 inches is citation for brook trout here in va so these are decent size. They are a little shriveled because I went for a couple hours while my primer was drying on my...

Do you reload at all? Also what range would these coyotes be that you would be shooting?

I would go with the 742 since its semi automatic which will give a quicker second shot than working the bolt on the model 700. Like has been said before at that range either one will do just fine.

Well I missed the contest but here is my Nyxie. She is a lab/collie mix and will be two in june. Rescued her while I was on christmas break in 09. She was outside the church basement window shivering in the cold and they let her in and she ran right to my dad and went under his jacket to keep...

Nice build, I have to the same size boat that I am trying to get wrapped it since its about that time of the year.

Got it done now to where its fishable with all the stuff except the very back finished and got it primed.

Bought it from lowes for 52 cents a foot. Has rubber backing and a two yr warranty. I also tried to stick a treble hook into it with pretty good force and it wouldn't really go in at all which I was very impressed by.

I was considering doing the same for my 14 ft flat bottom. I was thinking of attaching a piece of pvc pipe to the side with a big noodle in it to each side of the boat. Then maybe a 45 degree elbow on the front so it would run through the water a little bit better then capping the top of that.

Was thinking about putting some lights on my boat the meet the regulations for fishing at night in case I ever wanted to do some catfishing. I also happen to have some extra car lights lying around and was pondering the thought of using them. Anyone thoughts, concerns, or experience would be...

Carpeted floor and seats in for a test look. Boxed in the front to house the battery(ies), hopefully will have enough carpet for that this weekend but it will be close. Finally picked up the trolling motor, 50lb thrust minn kota powerdrive with foot control. Also rebuilt the carb in the outboard...

14ft flat bottom https://www.tinboats.net/forum/viewtopic.php?f=21&t=17758