srr5008
Well-known member
I'm hoping someone on this forum may have had experience with a similar setup. I'm trying to take apart my throttle assembly (see below pictures) and I am obviously missing something.
You can see in the third picture where the cast piece meets the painted metal. I am assuming once I get the plastic off of the throttle handle itself, that there will be a bolt that I can loosen to disassemble. However, I can't figure out how to get the plastic off without breaking it. I've been referring to the following 2 diagrams, but it looks easier on paper than it is in real life.
https://www.perfprotech.com/store/assembly/REMOTE-CONTROL-ASSEMBLY-(3000-CLASSIC),4891-70.aspx
https://www.perfprotech.com/store/assembly/Modular-Components(Design-II),8457-35.aspx
Any help would be much appreciated.
You can see in the third picture where the cast piece meets the painted metal. I am assuming once I get the plastic off of the throttle handle itself, that there will be a bolt that I can loosen to disassemble. However, I can't figure out how to get the plastic off without breaking it. I've been referring to the following 2 diagrams, but it looks easier on paper than it is in real life.
https://www.perfprotech.com/store/assembly/REMOTE-CONTROL-ASSEMBLY-(3000-CLASSIC),4891-70.aspx
https://www.perfprotech.com/store/assembly/Modular-Components(Design-II),8457-35.aspx
Any help would be much appreciated.
