Troutman3000
Well-known member
Think I found the culprit of my motor problems. The engine started acting up again today. It was the first time I ran it without the gumout in the tank so at first I thought it was the carbs. Well then I ran it at home and found this.
A bolt broke off because it was rusted, and I found water was already leaking where it was supposed to make a seal. Now half of the bolt is still in the motor. There is a steady stream from the bolt hole and the gasket. Is there any hope or am I just stuck. Could I use jbweld?
Any help would be much appreciated.
A bolt broke off because it was rusted, and I found water was already leaking where it was supposed to make a seal. Now half of the bolt is still in the motor. There is a steady stream from the bolt hole and the gasket. Is there any hope or am I just stuck. Could I use jbweld?
Any help would be much appreciated.