Hello everyone! My name is Reid and am new to the site. I have been surfing the site for some time now and love the builds that are on here! I have been wanting to do a jet jon project for a long time. We finally have the boat and the ski to do it with and will be starting on it soon. The boat is a 16 foot all welded monarch hull and the ski is a 97 Polaris SL 1050. We have the engine running and will be pulling it out of the ski next. We are decent at fabrication and have welded/worked on aluminum boats often. I have seen on the site that some of you have used aluminum intake housings from Yamaha jet skis in your builds. Since I don't have one on hand I was wondering if anyone knew if that intake housing would mate up with the pump from a Polaris? It may be a long shot, but maybe someone has tried it on here. We don't know a lot about jet ski pumps so this may be a broad question? I really like the fact that the housing and the shaft can be cut down to save room in the boat and just in general looks like a easier way to do it rather than fab out the housing from scratch. Thanks in advance and looking forward to sharing the build!