Recent content by Dennis8269

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Flexible Fuel filler hose needed for Tracker tournament v17

    Does anybody have a resource for a flexible fuel filler hose for my 97 tracker tournament v17 ? I need something flexible because from filler hole to tank it has to bend twice and seems to collapses normal fuel filler hose.
  2. D

    Tuff coat came out good

    I choose Tuff Coat because I got tired of hooking the carpet every time I am in a carpeted boat. The vinyl route would have been my second choice, the Tuff Coat being first because to makes the wood totally water proof and you can always continue to add coats over it in the future without any...
  3. D

    Tuff coat came out good

    The important thing is to prep. I did all wood and aluminum seating and hatches. The key when applying it after the primer of course, is to cross hatch to make sure and the rubber material even. Also, make sure the first coat drys before trying a second or it will lift the first coat.
  4. D

    Tuff coat came out good

    Thanks.I waiting for the weather to get nice to put it all in the boat. Then it will get the third coat and call it good.
  5. D

    Tuff coat came out good

    Restoring a 1997 Tracker Tournament v17. Using Tuff Coat which is coming out great,
  6. D

    What screw size for deck #6,#8 act..?

    I am trying to order some new screws online for the new decking on my boat. Not sure of the size # ? Thanks
  7. D

    What screws should I use ? Coat over them?

    Thanks for the ideas. I am loving this tuff coat stuff
  8. D

    What screws should I use ? Coat over them?

    So I have ripped out and replaced all wood in my tracker v17 . I am now Tuff Coating because I get tire of pulling hooks out of carpet. The question is would it be best to screw down deck then coat over the screws? Or Coat it then screw it down leaving head of screw exposed? The hole I make will...
  9. D

    Livewell intake 1 inch ID

    The hole in my transom for the livewell is 1 inch. All the livewell pumps have a 3/4 inch intake . If I run a 3/4 inch it seems to me it has a better change to leak. Will a 3/4 inch work with proper 3m 4200 around it? Found a 800 gpm livewell pump with 1 inch inlet. All is good.
  10. D

    What's a good material for deck templates?

    I used poster board. It is stiff enough to to lay flat yet easy enough to cut
  11. D

    Transom Live well drain needed

    Thank you
  12. D

    Transom Live well drain needed

    Well still restoring this 1997 Tracker Tournament v17. I am bolting up the new transom. On the transom the drain and the livewell bilge hole are 1 inch. Then the far left hole is the livewell drain which is below waterline. All the drains I can find say right on the description " not recommended...
  13. D

    Transom Material

    In regards of coating it. I am working on a Tracker v17 and used Coat It. The stuff is amazing not only waterproofs it but also strengthens the wood . https://www.amazon.com/Amazing-GOOP-5400040-Waterproof-Protector/dp/B083ZDYPDJ I coated the underside of all the wood in my boat and transom...
  14. D

    Is there a need for backing plate for pedestal base?

    Well I will have access until I screw the deck in :) I have though about that.
Top