Recent content by larryg

Final WET Sanding with 180 Grit Wash Down with 50/50 mix of White Vinegar and Water. Prime with Rustoleum Self Etching Primer Paint with Rustoleum Professional Oil Based Paint using the following formula. 1 qt paint 1/2 cup Acetone 2 oz Valspar Acrylic Enamel Hardener (Sold @ Tractor Supply)...

looks nice.yes it is ready for primer on bottom.are you gonna do the top also? i just did a 1973 lowline.i just have to carpet it and find some cheap under car graphic lighting kits for night fishing.good luck

this is a great lake for fishing in fl.there are no hp limits. they have many diffrent tournaments at this lake.Lake Toho TEAM Tournament Trail - Classic,BASS Master Weekend Series,Bass Busters Silver Division,Freedom Outreach Fishing Tournament CLASSIC.Lake Okeechobee is Florida's largest lake...

very nice project.how long is that bimini top.i have some poles that someone ws junkin but wasnt sure how to set them up.

thanks .had a few diffrent colors for the top so i had my son put them behind back and picked right arm.lol

well been a rough couple days since the last post.i got busy today and finished what had to be done.its 96% done all i have to do is carpet.been a long project but its done the way i wanted.had fun doing it.wheres the next one.lol thanks for looking.

rustoleum paint is not that expensive and last a long time.you should use a hardner,such as valspar from tractor supply.this makes the paint hard as a rock.i have done a few boats and motors and never had a problem with it.sand it all down,use the etching primer ans spray or roll on. paint...

ok you have a pull start motor according to the numbers on the model number.on marineengine you need rebuild kit #0393088.rebuild them because over time they deterioate.not sure of spelling.lol do not use anything but omc rebuild products .they last longer.i put two sierra kits in mine in a...

if you go into marineengine.com look under boat motor parts, click on evinrude and install model#.it post all parts for the engine.here is the link:https://www.marineengine.com/parts/johnson-evinrude-parts.php?year=1992&hp=15&model=E15RENM

finished all the wiring today.have to do the plumbing for livewell,trollin motor stand tomorrow and probaly paint the rest,depends on the weather.finished the front deck and storage area for anchor.

you basically have 2 options.one is to buy new tanks or build a vent for them.a guy posted this on my page.you have to see what your regulations are there.this would cover up the tanks being visible. Ventilation (Boats built prior to August 1, 1980) At least two ventilator ducts fitted with...

was wondering where everyone is keeping their anchors?..awhile back i seen a project where a guy used pulleys so he could sit in back and let his anchor down anyone know where i can find this.thank you

worked last 2 days finishing up the woodwork.tomorrow will be doing all the electrical and the plumbing. still hesitant about putting a hole in side of boat for overflow of livewell.can someone do it so when im out in the bay and it leaks i can blame someone else.lol still have to finish front...

i used it in a sprayer and rolled it.didnt notice a diffrence.i did it outside so i couldnt smell the fumes.i did autobody and those paints n enamels are worse,in my opion.

here is the bottom painted.top will be red.painted it the first time and would u know it wld decide to rain .so had to repaint next day.i used rusteoleum and added a hardner i got from a paint store.hard as a rock.next step is to finish inside compartments,wire everything paint the rest of the...