Makaw

I recently sold my 2010 Silverado pickup and spent a bit of time trying to find a new 2 door Bronco. It took some effort to find one at...

Assuming that everything else is good on the trailer you may consider taking it to a trailer shop or professional welder and ask them to...

Congrats @FuzzyGrub! Quite the upgrade from an old 14. I hope it suits you and your family well and you get lots of quality time logged...

Scheduled to pick her up on Thursday at 1PM. :) Highly likely, my last new boat purchase. Given my only other new boat was my 1st, a...

Basics............ Start with the basics. When you put the engine in the drum the water pump has to be covered with water. These pumps...

I managed to sneak in the first bottom coat after work.

Wow ... what a wealth of info here! http://www.fiberglassics.com/library/index.php?title=Main_Page Jim - Perhaps this should be a...

I’ve picked away at a few items since I last posted. New transom boards are glued, haven’t cut to shape yet. Jack plate boards are also...

Glad to hear it worked for you!

Thanks for the replies. The rivet's look good on the boat but figure a shot of epoxy could not hurt. The seams along the sides and stern...

Yup just this past week I’ve worked with the same 650 G/flex epoxy for exactly the same reason - sealing drip spots on my rivet seams. I...

First G/flex application tonight. Sealed the outer hull rivet seams. Took a minute to get adjusted to working with it, but it went on...

I’ve been picking away at little things this week. Most of the rivets have been re-bucked. Inside seams have been cleaned up and...

I’m also working on my jack plate. I was planning on using existing holes in the transom for the jack plate. Did a clamp test, and my...

Put a smooth radius on the edges of the bench supports. They’ve always been annoyingly sharp.