mbullen

White Oak, Mahogany, and marine ply are the usual suspects. The inner board/yoke thickness is dictated by the cavity in which it...

Oh yeah! Salt accelerates the whole equation. Marinas with leaky shore power, too. I guess I'm fortunate to be in the TVA freshwater...

Believe me ... it WILL cause problems if the boat is used is saltwater. Anyone with an old green or black Penn or black Garcia Mitchell...

Rivets would be aluminum in the length and diameter needed. (*solid rivets - usually a brazier, modified brazier, or universal head.)...

I'm not certain, but I think AT numbered their boats sequentially no matter the model, so the serial is only going to help with dating...

Standard procedure for the Aqueduct Transom is to remove the two small brackets in the splash well. Simple drill the rivets and lift...

Both Solas and Michigan Wheel offer a variety. 9, 9.25, and 10in diameters with pitches varying 7-12.

Thank you for your help. I must say the way you explained everything in such a fluent manner was a very pleasant surprise. You should be...

I have acquired this boat and have questions : The bow cap is aluminum, there is no fiberglass on this boat whatsoever. What year model...

Nice find! Traveler's "DUT" designated Deluxe Utility. The "-14HD" means 14ft, of course. HD being another level of...

Why not check available spark at cranking RPM first? The fact that it eventually starts and runs well tells me to look elsewhere. You...

To be fair, the bracket only has to be as wide as the mounting holes of the controls. If the aesthetics is a problem, a control...

in my opinion... Add a bilge pump regardless. But the boat was built for a short shaft 25hp motor. The 25hp was calculated by size...

The Penny's line was badged as "Foremost", I believe. Its been a minute since I've seen one. Maybe throw some pics up and it might ring...

Order the 584477 ignition coil. That is an OMC original coil. Universal coil for almost all engines of that vintage.