Recent content by Nlawson0017

i would also check out vance plates as well. I can say they are very well built and hold up in 30mph hard hits #-o and the customer service is top notch. -Nate

kinda looks like down around whites rd? -Nate

where on the licking was that. i aslo run the licking from mouth of ohio to famouth. -Nate

im getting 28mph up river in a 1648 with a tunnel, that's also 2 people 3 batteries 16 gallon of fuel and gear. -Nate

i have a 2010-2011 mercury 60-40 jet that will sound a alarm that is a solid beep for 5-10 seconds and then quits sounding. it happens at random times. i have idled for 10 mins and then a 3/4 throttle runs for a few miles and then back to a idle for a min it will sounds a alarm. ill shut the...

Thats some good looking fab work. =D> This build is coming along nice. -Nate

i forgot to post them pics for you.. hope this helps

Id say for every 100 boats with a outboard jet, maybe 1 of them have a tunnel. And alot of boats loose a mph or 2 after doing a tunnel. -Nate

i have a mercury control box that has the normal 5 wires but it also has a bigger plug that has a cap on it that says smart craft. i have no idea what this is for because i though to use a smart craft gauges i needed to come off the harness on the engine. if someone has any experience that would...

ok ive got my boat apart and welding away. and im tackling the transom next. but im having a hard time finding solid a answer on the height. ive got a mercury 60hp that i dont have the jet yet, so i cant take a measurement on it, and really dont want to do this twice. so.... i need to know what...

im looking for a jet setup for a 2001 mercury 60hp 2stroke. send me a pm with what u got and a price. 20in shaft thanks in advance. -Nate

im getting all my material to do a aluminum transom and other bracing on my boat and want to make sure i buy enough and the right thickness, to get rid of all the wood in the boat. i was wondering if anyone has pictures of a system that works great on a transom. also my transom was 2" thick so...

friends of mine take a straight piece of metal and hold it tight on the bottom of the boat and want a 1/2 inch gap between the straight piece and the rear of the tunes. i believe they do 1/4 inch up for every 7 inches off the transom. im sure u will get different preferred measurements from...

https://cincinnati.craigslist.org/boa/4015352012.html i actually know where the guy who is selling the boat lives. a good friend of mine lives right down the road from him. the boat is nice from what little i have seen. -Nate

im looking to make a set of pods while ive got the boat tore apart and i dont have my motor and jet drive yet. goin to run a 50-75hp and was wondering if someone with flotation pods can measure the width between there pods and tell me so i dont have the jet hitting a pod when turning. thanks -Nate