Recent content by outlawfan80

Thanks for the quick reply, 7/8" looks about what I have. I'll check them out.

I'm replacing the steering cable on a 1996 Evinrude 28 hp motor. How do I determine what size the tilt tube is so I get the right cable that will screw onto the tilt tube?

IN!!

Could you possably use the bolts holding your rod holders to attach some sort of clamp or bracket?

Thanks for the info. Tried it but couldn't get registered for some reason. I'll keep looking.

Thanks, I have found the parts book you are refering too. I would like to have an owners manual for reference.

Any one know where I can find an owners manual for a Minn Kota all terrain turbo 33AT bow mount? It was made in 1996. I've tried the company and they don't have one.

Do I need to install floor drains? My floor will be carpeted sealed plywood. At the rear there will be a storage area that the frame and sheeting will come down onto the floor this will also be carpeted. Will water seep through the seam between the two or should I install floor drains to allow...

I am wanting to cover the ribs on the sides of my boat with plywood and carpet. Would 1/4" plywood work or should I go with 3/8"?

Thanks for you info!! =D>

PM sent

What would be the best product to use to seal up the new wood framing and plywood decking and allow carpet adhesive to stick? Spar varnish, prime and paint, or ???

Sorry no updates. With Christmas, a 12 day hunting trip to Alabama and these lovely Ohio winters plus an outdoor garage havent done anything but think and plan. I can try to post my design if I can figure out how.

I ordered mine from Gemplers

I have used it on some equipment at work. All you do is clean off the loose stuff and apply. Seems to work good the paint is still on the equipment and that's been a few years ago.