Recent content by Piomarine

Ok so is the first motor I have had that uses both of these items. Is there anything special I need to do to service or clean the silencer? Likewise, what is the best way to go about servicing the starter? Should I even attempt to service it myself or just assume it’s bad and take it to a...

Very nice indeed!!! Was it a specific rust oleum paint you used for your top coat? Or just the basic rust oleum you can buy by the gallon?

I finally got the seat backs removed. The plan is to put them back in as they’re still in great shape, but they desperately needed a hardware change. Plus having them out will make it easier to strip the flaking paint off of the floor. Onward and upward

You’ll be happy to know that we are raising all of our kids up in the love of Christ!

This trailer I have is not perfect but it’s really adjustable and I think will be the best fit for this little boat.

Thank you! I love bringing my daughter out to work with me. She’s at the perfect age where she just wants help with everything!!! As for the transom, that is the backside of the wood the outer face side is completely gone. I considered restoring it but I was pulling 1 1/4” screw out without...

It took a lot of drilling and rivet punching but I finally got my inner transom wood pulled off! to my surprise it actually had the cork backer still on it 100% intact! The wood came off in one piece as well so both of these will be really good for templates! I had 2 of my kids out “helping”...

It’s been a good night! Got the back transom wood off of my ‘57 Deep C in one piece! Followed immediately by watching our Texas Rangers win their first World Series!!! Follow on question…what is the best way to drill out the rivets square to remove the braces in the splash well? I need to...

This is going to be the play right here!

I would like to have the vintage trailer with it especially since I’m also putting a period correct motor on it, but I am not married to the vintage trailer either. If it can be brought back reasonably then I would like to but if it’s going to be more trouble than it’s worth then I have the...

So when it comes to tongue length since the original needs a new tongue to begin (it’s bent because it was jackknifed) with I can pretty much make it as long as I want lol

This one looks a lot better cosmetically, but it was kept outside so there is some corrosion that needs to be dealt with. Also all of the rollers and bunks need replacing. Hubs and leaf springs are good, bearings need to be repacked and it needs to be rewired.

I bought a new to me 1957 Alumacraft Deep C runabout. I will be restoring the boat and keeping it a runabout. It came on the original Gator trailer and what I want to know is based one what you see is this trailer worth saving? The tongue is bent about 10° and the trailer was clearly...

I got all of the surface hardware removed from the hull this past weekend. What I am finding is that incorrect hardware was throughout this boat as I’m finding steel fasteners left and right all of which are heavily corroded. I will be removing the seat back as well to replace the hardware in...

Finally got the motor off and on a stand! My plan is not to use this UGLY ‘73 50hp but rather the ‘56 Evinrude Lark 30hp I am rebuilding in another thread. Next project will be getting the transom boards pulled off because that wood is shot. I do need some advice though. The 50hp motor the...