RaisedByWolves

FWIW a 50:50 mix of acetone & automatic transmission fluid (ATF) is the BEST penetrating solvent evah ... but you might have more...

Yeah, what pappy said. The lower units won’t bolt up. The thru hub will get you a better more efficient propeller, but short of better...

Measure twice, but once.:rolleyes:

I worked on one of these for a friend a few years back and it showed on my gauge about what you’re getting. No two gauges will read the...

I have tapped each threaded hole all the way thru then come from the back side with a quality bolt to create a stud. In one case I had...

I wouldn’t weld something like this anyway. Good rivets and a dolly for bending, would work or you could plan it out and have them bent...

Unless you’re going in and out of Haulover inlet the bench seats aren’t really necessary. Lots of people cut them out, myself included.

I finally have a full floor in my boat, which is great. The problem is until I get the rod locker’s built I have this gap that will...

Many times a manufacturer will have special bolts made for their particular product to meet there own specs! Was more common in years past.

Bow thruster. That is quite the rats nest you have there.

Yeah, you’re probably going to need at least another half turn and then adjust from there as per the manual.

Where is that at?

Nice score and happy kids. You done good!

Took the ride from Detroit to Chicago to pick it up with a clear understanding that it was a gamble on showing up and the boat being...

Had several 14' boats and ended up with hydrofoils on them all. At this horsepower level it doesn't matter which one you use. I've used...