Search results

got this engine running good at idle and at top speed - the problem I have is going from idle to top speed - it sometimes acts like it's not getting gas or it dies. it starts right up again and if I go from idle to top speed it goes most of the time - other times it dies or won't run good at...

Just picked up a new G3 1648 Jon boat -

what can be used for replacement fuel lines - I've seen some clear fuel lines used on newer motors

how does the water return after being pumped into the head - I see a very small hole at the bottom under the bottom cylinder - is that where the water exits the head. I just want to make sure that it is clean before I put the new gasket on

is 5052 .063 thick enough for floor and to build a front deck on my 1436 Alumacraft jon-

how thick should the aluminum flooring be - I would like use aluminum instead of plywood for the floor in my 1436 jon

need a fly wheel for an Evinrude 4 HP 1975 there are several motors that share this same fly wheel if you have one for any 4 hp give me the part number and i'll do the investigation

rebuilding a 1975 Evinrude 4 hp just noticed a crack in the flywheel - should I replace the flywheel or try to run the motor with a cracked flywheel - the crack runs from the outside to the center