Search results

I'm in the process of doing this now. I have the same motor.You will need a Clamp Block=Teleflex #SA27055p, Support Tube=TeleflexSA27274p, Bombardier/OMC #173209=Steering Bolt and Clevis kit. Add the proper length steering cable and a helm/wheel and that should do it for steering. Do you have a...

Compounded and waxed the hull.

1983 mirrorcraft 16' Northport troller. Got it from my brother in law for a good price.

Thanks Jeff for the pic instructions. I got it on here, sideways but here, from my phone. I'm no computer head by any means.

Some great idea's from everyone. Much appreciated. While cleaning up behind my shop, I found a piece of side console with part of the gunnel that I cut off of a old Manatee bow rider. After some initial trimming ,I think its going to work just fine. May have to move the pedestal seat around, and...

It could be the timer base. We just replaced a power pack on a 97 v-6 200 johnson and thought after ohming it out, that was it. We put a used timer base on it and it fired right up on all cyl. I also have a v-4 crossflow 90hp with no spark on the starboard bank., just have not had time to mess...

That is pretty sharp. I wonder if I can challenge my friend to build something similar? basically a pipe slid into a pipe, braces, a box to mount to, etc. It would take him some time as it would have to be a perfect build.

Well after a phone call to AJ McCallum, it looks like there is no stock available at this time. So i found a console made by Todd , #95-3005, polyetheline, not bad but a bit pricey around $400 Also found one by T-H marine, #SCM-2-DP, side unit made of tin and rather inexpensive at around $200 or...

I have a 83 MirrorCraft 16' Northport Troller with a 25hp Johnson tiller, Flat wood floor, single small pedestal seat mounted around mid ship. I have most everything I need to convert to remote steering and controls except a console. Besides fishing, I would use this boat alternately to run back...

I have a 83 or 84 MirroCraft 16' Northport troller, straight transom and its got a long shaft motor on it.

I'm in the process of buying a late 80's Spectrum 15' open skiff powered by a 1986 25 Evinrude and a Escort trailer. Trailer needs u-bolts/tie plates, and maybe an axle. Motor is pretty clean. Wood flooring is rough and needs to be replaced if even worth doing. Transom looks solid with no...