Search results

Well got my new tires on and removed the bottom leaf and took a test drive, all good.

I have 3, should I remove bottom or middle ?

Hello all, So my leaf springs are done, I have a 2006 Long trailer made in NC. The Co went out of business and I cannot find the same spring. After some research I found that they made there own springs custom for their trailers. I have a 16' Grizzly with a 25hp motor, I'm guessing my total...

Not even worthy of being called junk lol, It's funny that most folks that say there junk never owned one, while many folks that have owned one say they never had any issues.

Well I made a little homemade PF, no hurry to get this prop off so I will keep treating over the winter and maybe get lucky. If no luck by March the grinder it coming out.

I have more time then cash to spend on it right now, that will be plan B if I fail.

Been watching many vids on how to straiten a shaft with a hydraulic jack, looks easy. The motor runs great and has low hours. Have nothing to lose as the boat, motor and trailer was free.

Yes aluminum prop, I think it will need to be cut off.

Thanks for the reply, I don't believe there is any taper on the shaft. I believe it is a Mercury 13 spline prop as Mercury was building Force motors in the 90s Not sure heat will do it with the rubber insert. The prop is in fair shape but the shaft is bent, I may just go with it for now and...

Have a 1992 70 HP Force that has been sitting 15 years. It was a free boat and it runs great. The prop shaft has a slight wobble and was trying to remove prop so I can straighten shaft and identify prop pitch. Man it's stuck bad. I tried to make a puller with a pitman arm puller and some chain...

Yes I looked though don't see it anywhere.

It was a free boat, I took it for the trailer. It has been sitting for 15 years though it fired right up and runs great. Yes not the best outboard but many folks have had good luck with them.

I have a 1992 Force 70 HP and want to know what prop is on it. The number on the side is (DM 21824) I did a search on this number with no results.

Thanks for that info. Do you know what pitch prop you had and on what boat and what was your top speed ? Thanks.

Definitely, plugs and wires also.

Got a free boat,17' Capri on a galvanized trailer with a 70 Force outboard. Took carb off and cleaned, that it didn't need, hooked it up to a fresh gas can and it started right up. The boat has been sitting for 15 years and it runs great and pumps water. Anyone here have a 70HP Force ? Are...

Sorry for the late reply, I see a lot of folks use the blue Styrofoam board from Home depot or Lowe's. I used plastic water bottles in the front of my Grizzly.

lol, sometimes

Removed waterlogged foam from rear bench and installed hatch. Got well over 100lbs of it out, was able to leave the foam on top and remove the 4" of waterlogged foam from bottom. will fill back in with the blue foam from HD and put under floor to make up for storage space in bench.

What was your trick to get the foam out of them little holes you put in your bench? I cut a 6.5" hole and what a pain getting the foam out. I got about 30lbs out of left front and not done yet.