Search results

My buddy bought the aftermarket I pilot 2016 power drive V2. his plug is way different than mine and is not matching up to the new plug. anyone ever run into this ? trying to help him get it figured out. thanks in advance!

My buddy bought the aftermarket I pilot 2016 power drive V2. his plug is way different than mine and is not matching up to the new plug. anyone ever run into this ? trying to help him get it figured out. thanks in advance!

was doing some research on my ignition timing on my 2004 50D2 tohatsu after reading a the service manual online. according to the manual my timing link rod should be 5in and my throttle link should be 3.82in. I took a peak at mine out of curiosity and they seem to be flip flopped? is anyone...

Hey guys I'm looking for the cheapest marine carpet possible , I'm just using it to lay on my existing rubber floor for camping trip, the floors get too hot for the pooch and I don't want him to burn his pads. I need 6x14 ft.

Running my new to me Tohatsu 50MD2 (around 100 hours on it) yesterday and it was fine all morning, about to leave and I'm only able to reach about 3/4 throttle. Fires up fine , idles fine, sounds fine just wont go wide open. it doesn't bog down or anything just stays at 3/4 throttle. My initial...

This might be a stupid question but I am going to be re powering my 16ft v hull "starcraft no clue what model" with a 2004 50hp tohatsu, can I expect to see much better performance compared to my 1990 60hp mariner? I bought the new motor based on reliability compared to the mariner that I hated...

I recently purchased a kicker motor bracket. My thoughts are that I do not want or trust leaving that kicker on that bracket while trailering and may want to take it off during duck season.... I don't want to use the panther quick release for a few reasons soooooo... my thoughts are drilling 4...

Looking for any suggestions for a good waterfowl camo outboard cover for my 1991 60hp mariner. I have searched some that seemed pretty junky and didn't seem like they would fit true...

I'm sure this topic has been up more than once , in fact I thought someone on here had the same boat with the same project? Not having much luck with the search on here... Anyone have any pics or insight on converting this boat to open bow. A friend of mine wants so do this on his 16ft starcraft...

So i have been looking for a newer outboard for my 16ft starcraft. I currently have a 1988 60hp mariner that runs great but no power trim.... I have Been searching high and low for a newer outboard for a year with no luck. I started thinking about even just getting a cmc power trim for my...

Hey guys im considering buying a 2004 50hp merc. for my 16ft aluminum deep v, I currently am running a 1988 60hp mariner that tops out at about 31mph. My question is do you think i will get the same performance out of the newer 50hp??? any insight is greatly appreciated. Thanks!

Hello all rookie question, im looking for advice when it comes to steering cables. I need to replace the steering cable on my 16ft deep V (60hp mariner). I use this boat for duck hunting in very cold weather, as of right now the steering gets very stiff. What type of steering cable system should...

Hello all, im looking for advice when it comes to steering cables. I need to replace the steering cable on my 16ft deep V (60hp mariner). I use this boat for duck hunting in very cold weather, as of right now the steering gets very stiff. What type of steering cabel system should i be looking...

Hello all , im helping a friend with his recent boat and trailer purchase. He needs to replace his bow stops, the problem is there are two of them and they are oddly shaped. I dont have a pic at the moment but will try to get one they are not like the traditional bow stops the are kind of...

I have a 12ft Mirrocraft on a trailer with a 9.8 merc 110 as well as a newer electric trolling motor and battery. everything is in great condition. I live 5 minutes from Presque isle bay on lake Erie (not sure what effect my location would have). Just wondering what you guys might try getting...

Can anyone give me a ballpark figure on how fast my 9.8 merc should push my 12ft mirrocraft, i havent had a gps on it yet to really say how fast im moving, just doesnt seem like its pushing it as well as it should. thanks!

Ok fellas... I went out to run my merc in a barrel this morning because i havent ran it in about a month , It started right up and started spitting warm water with good flow.... after about 2 min it went from spitting warm water to hot water,,, hot enough that i couldnt hold my hand under for...

quick question that im sure has been asked before but im going to ask specific.... i have a 9.8 mercury thunderbolt 110 mid 80s i believe, i have it on my 12ft mirrocraft, if i put a hydrofoil on it would i see much better performance??? should i be getting on plane somewhat in a little boat...

I have been looking high and low for a transducer mount that i do not have to drill holes in my boat. I found a few but they are quite expensive and im not sure about the suction cup ones which are also not cheap. Im looking at getting the lowrance X-4. i have been racking my brain tryin to come...

Hey guys was wondering about a transom saver... i have a 12ft alum. mirrocraft with a 9.8 merc, it seems to bounce quite a bit when trailering it. should i look at getting a transom saver or is there different options, i know some of the transom savers have electric outboard requirements. anyway...