Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    1990's Lowe Fish/Ski 17.5?

    Thanks for the reply. I did a little digging and it looks as tho it is real close to the Merc motor.
  2. T

    1990's Lowe Fish/Ski 17.5?

    I am looking at a 1991 Lowe Fish/Ski this weekend, has a 115 Mariner 2 stroke and Merc 9.9 4 stroke kicker. Askin $6500, hope to get a little cheaper. I have heard mixed reviews on Lowe. Some great, some say they are at the bottom of the list. Looks like new on the inside and out. Low hours on...
  3. T

    *****HOW MUCH FOAM DO I NEED*****

    Would the pourable foam help seal up and small leaks ? Looks like some sweet stuff.
  4. T

    1982 Alumacraft Calssic 16: New Life

    Well, can't seem to turn last pic. Hopefully will get some in action pics soon. Then, fill her up with poles and tackle and see how the eyes are biting! Or 'gills, no matter! Pretty pumped about the trolling motor, should move her around real nice. Had the 45 Merc tuned up too, so anxious to...
  5. T

    1982 Alumacraft Calssic 16: New Life

    Not the prettiest girl out on the water, but, its a 30 year old fishin boat eh? Leaving the outside, sick of workin on it. Need to wet a line!
  6. T

    1982 Alumacraft Calssic 16: New Life

    Other rear shot. can see charger plug. Front shot of deck. Removable battery door. Moved front chair forward to clear batteries. Raised 1 1/2" and new 3/4" deck. Door removed. New boxes and 6 AWG cable tinned runs thru 1" PVC Schedule 40 scrap had laying around, runs to front access...
  7. T

    1982 Alumacraft Calssic 16: New Life

    Slid ahead Console: new switches and also added some where the old fuse holders were. Also mounted a 3 bank NOCO onboard charger inside left in console. Front leads run thru floor to deck for 24 volt troller batteries. Blue Sea 12 fuse block mounted underside with negative buss bar near also...
  8. T

    1982 Alumacraft Calssic 16: New Life

    Well, lost last post so will try it again. Rear seat area: Modified and removed about 12" from front of whole bench. Where gas tanks sit now there was foam with bench screwed to supports with aluminum panel goin across the front. Battery sits in close to original location in new box. Whole...
  9. T

    Tube Style Rod Storage?

    Been kicking around the idea of installing a few PVC pipes into the front of the bow for rod storage. Boat is 1982 Alumacraft Classic 16. Front deck sits about 6" above floor and is 4' long. Rod locker runs on left side from back of front deck to rear about 1' wide 7' long. Top of locker is...
  10. T

    New Wiring-Mods

    Got a ? on the front nav lights. The front lights that came with boat are mounted on a pole about 6" tall. Do I need to keep them that high? I picked up a new light that mounts on bow, only 1 1/2" tall. Trolling motor may ubstruct right side a bit, but, is the extra height needed? Also if I am...
  11. T

    New Wiring-Mods

    Well, I have most of the wiring done. Mounted a 12 place Blue Sea fuse block under console. Feeding it is 10/2 AWG sheathed from rear battery. Need a good 30 amp fuse setup yet to mount near battery. Ran 16/2 AWG sheathed from console to rear for bilge and aerator pump. The ground wires off...
  12. T

    New Wiring-Mods

    Howdy, recently signed up but been lurking for some time. Great info here. Just bought a 1982 16' Alumacraft Classic 16, 45 hp Merc. Going to upgrade from old 12 volt to used 24 volt Minn Kota w/ co-pilot. I am moving trolling motor batteries up in front and under front deck to transfer some...
Top