Search results

I am about to strip and paint my jon boat... I plan on: 1...stripping all the old grey paint off with stripper. 2...sanding with a medium grade sandpaper over entire hull surface. 3...clean with acetone. 4...apply an epoxy based sealant/primer. 5...apply self-etching primer...

ok...........same motor, 71 Evinrude 18HP, different issue. It has done this to me a few times and usually when it first gets started and warming up. I will be going across the water and get a jolt from the motor. Not strong but enough to shake the boat a little. It is not from the motor...

I synchronized my linkage and cleaned the carb. I tore apart the fuel pump and rebuilt it. I bought a new gas tank and supply line and put on new plugs.....what else. I got it started after it sat for about 3 years. It ran rough, but it ran. It quickly died on me and I diagnosed some easy...

I am about to start my new project on a flat bottom. I was recently given a 16' Duracraft with an 18HP Evinrude. I was totally ignorant about doing anything to my boat, other than fishing from it, until my buddy told me to add a flipping deck to it. So I hit the internet looking for guidance...