TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
1991 Bass Tracker Pro 17 elec wiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MrGiggles" data-source="post: 476901" data-attributes="member: 22613"><p>I doubt you would ever find a wiring diagram.</p><p></p><p>There really was not much to it on my 84. I'd say yours is pretty similar. There was a small harness that ran from the bilge to the console, with wires for the bilge, aerator, and nav lights, and two larger power/ground feed wires that went right to the battery. They terminated at an old glass fuse panel and a ground buss bar in the console.</p><p></p><p>If the wiring harness is mostly intact, check the wire colors at the bilge and fresh water pump, they should be the same color at the console. Same with the lighting.</p><p></p><p>The outboard harness ran along side it, but was in a separate loom and pretty much separate altogether.</p><p></p><p>There were also wires that ran to the bow, two heavier wires for the trolling motor plug, and a 3 conductor harness for the tilt/trim switch.</p><p></p><p>If in doubt, you can always get a multimeter and run continuity tests to figure out which wire goes where.</p></blockquote><p></p>
[QUOTE="MrGiggles, post: 476901, member: 22613"] I doubt you would ever find a wiring diagram. There really was not much to it on my 84. I'd say yours is pretty similar. There was a small harness that ran from the bilge to the console, with wires for the bilge, aerator, and nav lights, and two larger power/ground feed wires that went right to the battery. They terminated at an old glass fuse panel and a ground buss bar in the console. If the wiring harness is mostly intact, check the wire colors at the bilge and fresh water pump, they should be the same color at the console. Same with the lighting. The outboard harness ran along side it, but was in a separate loom and pretty much separate altogether. There were also wires that ran to the bow, two heavier wires for the trolling motor plug, and a 3 conductor harness for the tilt/trim switch. If in doubt, you can always get a multimeter and run continuity tests to figure out which wire goes where. [/QUOTE]
Verification
Post reply
Forums
Boats
Electrical
1991 Bass Tracker Pro 17 elec wiring
Top