TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
CMC Pt 130 Tilt and trim installation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="sbritt23" data-source="post: 307861" data-attributes="member: 11029"><p>Alright i have a quick question. I have 2 choices on how to install this im putting it on boat that is brand new and never had a motor on it. So my 2 options are i could hang my motor on my transome and use c-clamps to pull it tight to the transome and mark the holes. 2. install the tilt and trim unit to the motor and use a hoist, or cherry picker to jack the motor up and put the transome plate up to the transome and jack it up until its to the desired height and install like that. what do youll think would be the best option i really dont wanna drill a bunch of holes and the intstructions are unclear about this cause it says take old motor off set CMC to desired height and install and make sure you leave enough clearence so the motor can tilt anyone that has any insight please post. I appreciate all the feedback thank you</p></blockquote><p></p>
[QUOTE="sbritt23, post: 307861, member: 11029"] Alright i have a quick question. I have 2 choices on how to install this im putting it on boat that is brand new and never had a motor on it. So my 2 options are i could hang my motor on my transome and use c-clamps to pull it tight to the transome and mark the holes. 2. install the tilt and trim unit to the motor and use a hoist, or cherry picker to jack the motor up and put the transome plate up to the transome and jack it up until its to the desired height and install like that. what do youll think would be the best option i really dont wanna drill a bunch of holes and the intstructions are unclear about this cause it says take old motor off set CMC to desired height and install and make sure you leave enough clearence so the motor can tilt anyone that has any insight please post. I appreciate all the feedback thank you [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
CMC Pt 130 Tilt and trim installation
Top