TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
CMC Pt 130 Tilt and trim installation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="toofuss" data-source="post: 307902" data-attributes="member: 10967"><p>Ok then this should be simple. Set your tilt/trim flush with the top of your transom and DEAD CENTER!!!! I cannot stress this enough. Then set your motor to the trim unit in the top holes (high as it will go) that way you can always go lower if needed. Another thing to watch is level and plumb. Just a degree off can make the boat squirrely at speed. Hope this helps.</p></blockquote><p></p>
[QUOTE="toofuss, post: 307902, member: 10967"] Ok then this should be simple. Set your tilt/trim flush with the top of your transom and DEAD CENTER!!!! I cannot stress this enough. Then set your motor to the trim unit in the top holes (high as it will go) that way you can always go lower if needed. Another thing to watch is level and plumb. Just a degree off can make the boat squirrely at speed. Hope this helps. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
CMC Pt 130 Tilt and trim installation
Top