TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Expert please chime in help needed!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="huntinfool" data-source="post: 355928" data-attributes="member: 1931"><p>I'd say either approach would be acceptable. I'd probably take the floor out and remove foam, just to make sure there wasn't any other damage (like any cracks to ribs or between rivet holes.) Then just put some foam in it ( poured or block/sheet and reinstall the floor. </p><p>But blind rivets should stop the leaks and save you time.</p></blockquote><p></p>
[QUOTE="huntinfool, post: 355928, member: 1931"] I'd say either approach would be acceptable. I'd probably take the floor out and remove foam, just to make sure there wasn't any other damage (like any cracks to ribs or between rivet holes.) Then just put some foam in it ( poured or block/sheet and reinstall the floor. But blind rivets should stop the leaks and save you time. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Expert please chime in help needed!
Top