TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Ideas needed for trolling motor handle extension
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jkbirocz" data-source="post: 33659" data-attributes="member: 107"><p>What is the diameter of the handle? I think you could get away with clamping pvc pipe to the handle. Just cut two to four channels into the pipe where it will slip onto the handle. Then get some exhaust clamps and clamp it down tight. I think that would work fine as long as the pvc is under 2" after that it gets much stiffer.</p></blockquote><p></p>
[QUOTE="jkbirocz, post: 33659, member: 107"] What is the diameter of the handle? I think you could get away with clamping pvc pipe to the handle. Just cut two to four channels into the pipe where it will slip onto the handle. Then get some exhaust clamps and clamp it down tight. I think that would work fine as long as the pvc is under 2" after that it gets much stiffer. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Ideas needed for trolling motor handle extension
Top