TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Newb and Doing A Little Conversion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BassnFool" data-source="post: 429738" data-attributes="member: 22076"><p>Thanks for the replies. I thought it was strange myself, but this is what I'm working with. Ion going to re-rivet that entire section. I'm going to apply 5200 on each rivet, but I'm also wondering if I should remove both sides and try to fit it in the seam as I go from bottom to top.</p><p></p><p>Should I fill that gap in the inside?</p></blockquote><p></p>
[QUOTE="BassnFool, post: 429738, member: 22076"] Thanks for the replies. I thought it was strange myself, but this is what I'm working with. Ion going to re-rivet that entire section. I'm going to apply 5200 on each rivet, but I'm also wondering if I should remove both sides and try to fit it in the seam as I go from bottom to top. Should I fill that gap in the inside? [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Newb and Doing A Little Conversion
Top