I am going to make one like this: https://www.tinboats.net/forum/viewtopic.php?f=3&t=10823
I am debating using aluminum plate vesus treated wood for the plate itself.
A lot of guys on iceshanty.com set up minnow tanks to save their bait.
I do not know about CO but in MN I believe that if you catch your own you can only use it in the body of water it was caught in.
Good luck
I looked at a post of a great transom raising mod. There aren't any short shaft motors being made in the HP I want. I have been looking.
The short shaft is 15". A long shaft is 20". If you raise the transom 5" and hang a long shaft it shouldn't change the handling dynamics. Except for maybe a...
I have a 16' tin boat that currently has a short shaft motor that needs to be replaced. The boat is rated for a 50 horse. It has remote steering and tilt and trim. The motor is shot.
In searching for a replacement I haven't come up with any good options in a short shaft.
Has anyone added 5" on...
One of these will insure that the tow vehicle is good to go:
7- and 4-Way Circuit Tester
Debug Plug
I use mine when the lights aren't working right. Then I am sure the problem is with the trailer and not the tow vehicle.
The socket on the truck was a bit dirty. I plugged in the debug plug...
Talk to these guys and they will tell you that they are a bit of cheap extra insurance:
https://www.crashedtoys.com/
If the straps fail in a sudden stop boats tend to come off and keep moving forward into the tow vehicle.
I get the grill preheating.
I take the skin on trout fillet and drizzle on olive oil.
Then I sprinkle a bit of salt and pepper followed by one or two dried herbs. A bit of lemon if I am in the mood.
Put them on the grill skin side down for about 10 minutes.
Easy and pretty good.