Got quite a bit done the past couple of days. I rebuilt the passenger side of the dash. I had to use my jigsaw to cut the 3/4" poplar. I then sealed it, covered it, and installed the storage compartment. I got the top covered with carpet and split windshield installed. I also got the front...
Yes I read your post about the rivets. It seems I've been spending a lot of time reading this forum and trying to learn as much as possible. Thanks for the reply and posting your project.
I got the hatch lid built and covered. I want to make sure no seams would lift up since it is in a high traffic area. The aluminum trim in the floor protects the floor. The vinyl is tucked under the bottom and then has a 3/8" X 2" trim piece stapled over it to protect the vinyl and make it...
Lon, I'm with you on the front batteries. I'm going to secure them so they don't move/bounce. I definitely want as much weight up front as possible. On your question of why two batteries, I don't have to have two, just more secure. I'll be using a Perko switch to select between them. That...
Got the remaining carpet cut and glued on the inside today. It was a task of patience. I didn't realize how difficult it is to cut carpet to fit on a curved surface. I must have climbed in and out of the boat 50 times to cut and recut carpet. Most of the seams came out really good. I going...
It is hard to keep track. I spent over three weeks getting all the paint off the outside. I would say I have over 100 hours already into it, but it is hard to say.
Brine is correct on the plywood. Use an exterior grade plywood. I suggest sealing/painting before you lay it down and cover. This will help protect it from moisture. Good luck and have fun!
After some debate, I decided to cover the nose and gunwales in three pieces. I did the nose separately and then the two gunwales. I cut carpet so I could clamp the pieces on and then trace the carpet from underneath. I then took the carpet off and cut them out on the driveway. I then used...
Got to spend a few hours this afternoon and laid the vinyl flooring down that I ordered from Cabelas. I ordered the gray/charcoal flooring. I cut the piece down to leave about an inch or so on each side. I laid it as one solid piece vs. covering each piece of the flooring. This will make it...
I used my new Porter Cable jigsaw with a fine tooth blade. I traced the old piece and cut it out. I then took a file and filed off the edges. It was actually pretty easy, just have to take your time and be patient.