I have a 1966 18 Hp Evinrude Fastwin that I am tuning up, Does anyone know exactly what the compression should be on this motor? Just ran a test and am getting 110 psi out of both cylinders. Is this adequate?
Thanks in advance
Thanks again Pappy :beer: Now if I could just find out for sure the actual size of the o-ring that is supposed to be there, cause I really don't believe it was the little tiny thing that was enclosed in the bag. But, the one I put on there looks about right
The drive shaft in my 18 hp evinrude has some wear on it where the Impeller seal goes, and I'm not certain, but from what I've been reading it might be a good idea to get it repaired. My question is: Should I have a Machine Shop do it and know it's done right, or should I try and put a sleeve on...