wmk0002

Yes, same mix, no thickener (cabosil) added. This transom was all 1/4" hardware, so likely 3/8"+ sized holes, nit sure if I mentioned it...

Dale, do you use the same epoxy you coat the transom board with to fill in the oversized fastener holes? How oversized do you go? Seems...

Yeah lol. That's 140 lbs per person. Would be a tight squeeze with any more than 2 adults I bet. Im actually wanting this second boat...

4 people or 560 pounds. I don't think I know three other adult males who along with me would come under 560#. Haha.

I bough this 1989 Fisher Marsh Hawk 3V a couple of weeks ago as potential winter project. It is a 16' x 48" mod-v riveted hull. The boat...

FWIW: I looked in the 2022 Yamaha 75/90 manual. Even though it is a jet, you get the prop operators manual. I could not find any...

Interesting....went thru my Merc factory service manual and no mention of trailering in gear. In my 60 plus years of boat ownership...

Are the new non-oem ones actually any good? I've been looking for some used Yamaha controls for my 1988 30hp but most are pretty junky...

Just my 0.02, but I've never noticed much difference between trimming down an aluminum boat like that for holeshot. I typically set it...

That thing is nice.

Stroke length is pretty universal (couple variations) as is trunnion to engagement pin. There is more than one pin location in the...

Does it have a Yamaha 703 style control box? I think you can take them apart and reverse the throttle push/pull mechanism. Yamaha...

I bought some 3M surface mount sip tie holders off Amazon recently. Put them on the transom on one boat to route the transducer wires...

I agree about eTrailer. They are also very responsive to questions -- even my dumb ones.

Awesome. Maybe down the road you can help me out.... mine did not include the console or steering system. I like to somewhat match the...