Zberry1985
Active member
- Joined
- Apr 16, 2020
- Messages
- 25
- Reaction score
- 0
Picked up a parts motor 0A745967 to take the tilt and trim from. Anyone have a service manual for the tilt and trim? Or know how much fluid it should take?
It ran slow up and down to start with, I was hoping it just needed to be topped of with fluid and air bleed out. I raised the motor up and locked it up, topped of fluid ran it a few times letting it sit a few minutes between cycles. It still was running slow so I tried loosening the vent screw and fluid bubbled out violently and I dropped the screw. Went to the store to get more fluid and when I came back the trim motor won't spin anymore as if it's lockedup\binding. I took the motor apart and cleaned the brushes, I can tell it's getting power just not spinning free. Also turned the pump with an allen wrench like the motor shaft, it turned easily but would spin back a bit like it was a little springy. Any ideas why the motor stopped working?
It ran slow up and down to start with, I was hoping it just needed to be topped of with fluid and air bleed out. I raised the motor up and locked it up, topped of fluid ran it a few times letting it sit a few minutes between cycles. It still was running slow so I tried loosening the vent screw and fluid bubbled out violently and I dropped the screw. Went to the store to get more fluid and when I came back the trim motor won't spin anymore as if it's lockedup\binding. I took the motor apart and cleaned the brushes, I can tell it's getting power just not spinning free. Also turned the pump with an allen wrench like the motor shaft, it turned easily but would spin back a bit like it was a little springy. Any ideas why the motor stopped working?