Recent content by Cheeseball

Very cool post. Thanks!

No problem my friend. Happy moding!

Popeye: Yes, the wire is hammered into the pipe. I hadn't thought that far ahead about replacing it. I guess I would drill a hole in the end and bolt a new one on. Truck: Look at the pic below. I'll mount the pos and neg busses approximately where the little white box is on the seat. The whole...

Finished project. Made two of these one for positive one for negative for about $7.

Welcome to the site! Anxious to see what your going to do.

I'm no electrician. But here's how I did mine. https://www.tinboats.net/forum/viewtopic.php?f=5&t=5668&p=128485#p128485

Yes, I'm still here, progress on my boat is going slow but I have made a little head way on the buss side project. Here's what I've come up with so far. I still need to hammer the pipe flat and drill holes for the studs, but you get the idea. Another angle... These two SS self tapping...

Really like your design! Very efficient use of the space and it looks sturdy. =D> How thick is that decking material?

Sweet motor! Boat looks like a nice fixer-upper. Go with aluminum or a combination of aluminum and wood.

Personally, I would attach it but make it so it's easy to take back out. Maybe 4 bolts holding the whole thing down. The project I'm working on now, I'm not going to put a floor in at all because I want to stay light.

Maybe put a floor in, but I wouldn't make a raised deck. Add some navigation lights, cockpit lights if you're going out early or comin in late.

Very nice looking seat framing! I have those same seats for my project. Man, after all that sweet work you all did on that highback transom and now you're gonna cut a hole in it? [-(

I don't know that there is a best angle to use. I think it depends on your situation. I used 1 1/2" angle, a combination of 1/8" and 1/16" thick. Using the 1/8" thickness for longer spans and places bearing the most load. I used the 1/16" as braces and framed most of the back deck. Front got...

Welcome to the site! Very nice boat... reminds me of Codeman's project.

Thanks for the compliment, I've really started enjoying this project now that the paint stripping is done. This is the first time I've worked with aluminum angle and yes, I find it very easy to work with. Pop rivets work great and are easy to use. Just make sure you spend the extra $ for a...